Diy Ferro Rod Handle

I see lots of folks have the tape duck or gorilla handle with some cordage on their blank ferro rods my thought is to just lay the cordage down with some excess below the initial tape wrap make a a pass or two then fold back up the excess and complete the wrap this should secure it with stirrups in a sense like a bandage for those that are familiar and minimize potential for slippage.

Diy ferro rod handle.

Place a piece of wood under the antler let the drill do the work and don t press too hard. The threads inside the handle may be a bit tight because of glue residue try screwing in out the bolt a few times to clear them out. Most ferro rods come with a paint or some sort of coating that prevents oxidation. Hi and welcome to another instructable by me capsos i do hope you enjoy these and please make sure you check out my other instructables on here also with that if you are into bushcraft or would like to see a little more on what i teach then please.

To make a custom handle you will just need a few materials. Diy custom ferro rod handle ferrocerium is a man made metallic material that produces hot sparks at temperatures of about 3 000 c 5 430 f when scraped against a rough surface pyrophoricity. Ferro rods are great to carry around for making fire in any situation whether its camping survival backyard fun etc. After you put it together try resisting the urge to repeatedly screw in out the rod the threads will wear down because ferrocerium is relatively soft.

Making a ferrocerium rod handle. If you seat the ferro rod in the socket temporarily it gives you a handle to hold on to while drilling the lanyard hole. The hotter the sparks the more efficient the ferro rod. In this video we are finishing up the bushcraft knife and sheath build with a custom handle for my ferro rod.

Thank you for reading have fun making and using your own. First buy yourself a plain ferro rod like those in the hooddeal ferrocerium rod pack. Drill bit the same diameter as the ferro rod. You want to do all the work needed to the antler before gluing that way if you chip the antler and want to start over you can.

Then make your own ferro rod handle. A general rule of thumb is that you should see a shiny area on the rod where you will scrape. Diy ferro rod handles. If you are good with your hands and looking to take on an easy project a diy ferro rod is a great way to add some personality to your survival gear.

Problem is this coating needs to be gone before a spark can be created. Drillable handle material wood plastic bone etc super glue.